I have built a complete kit this weekend, and it seems to work but not quite as it should.
The red signal seems to be way to high on the left side and peaks at the left.
The green signal which doesn't seem to work at all.
What could this be? I have tried various jumper settings, double checked my solderings.
PCB 6.8usb / 5.7 with the 12cm ferrite rods from Egon.
Can you take a photo of both boards and post it here? The rings of the resistors should be recognizable on the photos.
cu, Robo 
What happen to signal if you turn your antenna pair 90 degree clockwise or anticlockwise?
What happen to signal if you turn your antenna pair 90 degree clockwise or anticlockwise?
Nothing it stays the same, green signal doing nothing and the red detecting some signals but rarely strikes.
robo i've uploaded a few high res photo's here:
Thanks for the pictures from below the PCB. Your soldering doesn't look good. I'm sure, that bad solder joints are the cause of your problems.
Please have a look at some soldering howtos. I'm sure there are a lot of on the net. We can not give much help for that.
Thanks for the pictures from below the PCB. Your soldering doesn't look good. I'm sure, that bad solder joints are the cause of your problems.
Please have a look at some soldering howtos. I'm sure there are a lot of on the net. We can not give much help for that.
Allright I did redo some joints it seems that the values are where they are supposed to and the green channel seems to pick up something as well. 
